Popular Articles
mastRcam (Before Practice) - Systems Check / Functionality
Before raising the mast, we want to make sure functionally all the equipment is working. 1. Turn on power – Turn the red power knob on the console dashboard to the ON position. The inverter controller should turn on immediately where the cameras, ...
mastRcam (End of Practice) - Charge mastRcam
The batteries of the mastRcam can typically go two practices between charging, but there’s no harm in charging the mastRcam after every practice. If the volt meter on the Console Dashboard reads 11.6 volts or less, then the mastRcam will need to be ...
mastRcam - Compressor Wont Turn On
1. Make sure the main power knob is ON as well as the inverter. The purple inverter controller, if it's on, should show a voltage reading. 2. Make sure the compressor switch on the dashboard is in the UP position 3. Make sure the mast control switch ...
mastRcam - Steps to factory default Kisea inverter.
Turn off inverter (If not already off) Turn on inverter When inverter is showing voltage press and hold the “power” and “select” button at the same time until “CU” is shown on the display. With “CU” on the display press the power button several times ...
mastRcam - Gray bars appearing in video (HD-100)
This is a normal function with the stabilizer (HD-100) trying to stabilize the video while the camera is moving. However, if you want to turn the stabilizer OFF, then here are instructions on turning it off (depending on what version controller you ...