mastRcam (End of Practice) - Charge mastRcam
The batteries of the mastRcam can typically go two practices between charging, but there’s no harm in charging the mastRcam after every practice. If the volt meter on the Console Dashboard reads 11.6 volts or less, then the mastRcam will need to be charged before the next practice.
The mastRcam requires a 20amp power circuit with a 12-gauge power cord (included with the mastRcam).
1. Plug the shore power into the Power Inlet on the front of the trailer. The green “Charging/Shore Power” LED light will light up if power is detected and the trailer is charging.2. Inverter will power on and, if charging, will show one of the following messages:a. FUL - By-Pass Mode. Battery is fully charged.b. BUL-CHG - Battery charging in progress.c. ABS-CHG - Absorption mode. This means the batteries are 90% charged.
If the trailer is NOT charging when shore power is plugged in, open the right side hatch AC/DC Panel and make sure the 120v AC Breaker is ON.
Related Articles
mastRcam Operations Checklist - End of Practice
Below is a checklist that covers all the basics of using the mastRcam at the end of practice which includes breaking down all the components, preparing the trailer for storage, and charging the mastRcam. Lower Mast Remove Camera Housings or Put on ...mastRcam SC (End of Practice) - Charge mastRcam
The batteries of the mastRcam SC can typically go two practices between charging, but there’s no harm in charging the mastRcam SC after every practice. If the volt meter on the Console Dashboard reads 11.6 volts or less, then the mastRcam SC will ...mastRcam (End of Practice) - Disconnect Guy Ropes & Close Bimini
If you attached the guy ropes to the mast for practice, you will want to disconnect them at this time. If you plan to use the guy ropes at the next practice, you can just disconnect them from the eye-bolts on the trailer and leave them connected at ...mastRcam SC Operations Checklist - End of Practice
Below is a checklist that covers all the basics of using the mastRcam SC at the end of practice which includes breaking down all the components, preparing the trailer for storage, and charging the mastRcam SC. Lower Mast Remove Camera Housings or Put ...mastRcam (End of Practice) - Turn Off Power
Turn the red power knob on the console dashboard to the OFF position. The inverter controller (purple box next to the red power knob) will stay on, so you need to press and hold the power button on the controller for a couple of seconds and it will ...