mastRcam - Compressor Wont Turn On

mastRcam - Compressor Wont Turn On

1. Make sure the main power knob is ON as well as the inverter. The purple inverter controller, if it's on, should show a voltage reading.
2. Make sure the compressor switch on the dashboard is in the UP position
3. Make sure the mast control switch is set to "RAISE"
4. Drain all the air out of the compressor tanks manually by opening the valve on the bottom tank. Twist the valve slowly to release the air. If a lot of water also comes out, it's possible the water was interfering with the pressure instead the compressor and now with it all drained, the compressor should turn on.
5. If that still doesn't work, try plugging the compressor directly into shore power instead of the inverter. If that works, the issue could be the compressor is trying to draw too much voltage and the inverter is not allowing it. Try plugging the compressor back into the inverter and see if it will turn on now that it had been unplugged from the inverter. If the compressor will not work when plugged back into the inverter, then the compressor needs to be replaced.

    • Related Articles

    • mastRcam SC - Compressor Wont Turn On

      1. Make sure the main power knob is ON as well as the inverter. The purple inverter controller, if it's on, should show a voltage reading. 2. Make sure the compressor switch on the dashboard is in the UP position 3. Make sure the mast control switch ...

    • mastRcam (End of Practice) - Turn Off Power

      Turn the red power knob on the console dashboard to the OFF position. The inverter controller (purple box next to the red power knob) will stay on, so you need to press and hold the power button on the controller for a couple of seconds and it will ...

    • mastRcam (Before Practice) - Raise Mast

      Now you are ready to raise the mast. Again, make sure there are no obstructions above the mastRcam that the mast could hit and that the trailer is properly secured with the stabilizer legs. To the left of the mast, there is a valve that allows you to ...

    • mastRcam Operations Checklist - End of Practice

      Below is a checklist that covers all the basics of using the mastRcam at the end of practice which includes breaking down all the components, preparing the trailer for storage, and charging the mastRcam. Lower Mast Remove Camera Housings or Put on ...

    • mastRcam (Before Practice) - Secure and Level the mastRcam

      With the mastRcam in the spot you want it, the next step is to secure and level the trailer by lowering the stabilizer legs to the ground. 1. The first step is to make sure the wheel jack is touching the ground. 2. Next, on the Dashboard, locate the ...