RP-150 Controller - Remote Power On/Off Your Camera

RP-150 Controller - Remote Power On/Off Your Camera

If you ever need to reboot your camera, but don't want to leave your controller station, you can use your RP-150 controller to remotely power on or off your camera:

1) On your controller, press and hold the appropriate Camera Select button. Most likely, your camera is going to be Camera 1.

2) After holding the camera button for a few seconds, a message will appear on the touchscreen showing the current camera you've selected and what its current power state is. It's important that you have to continue holding the camera button, because once you release that button, this message will disappear. Press the ON or OFF button to power your camera on or off.

    • Related Articles

    • RP-120 Controller - Unable to control camera

      1) First power cycle both the camera and controller 2) If that doesn't fix the issue, press button 36 CTRL TYPE and make sure CAM 1 is set to "Serial" 3) Also make sure that the 422 cable connecting into the controller is in Port 1 (But not the LAN ...

    • RP-120 Controller - Factory Reset

      It's possible for the RP-120 controller to lose its settings especially when it's being connected/disconnected every day. If the controller no longer will control any camera it's connected to, do the following: 1) On the controller, press the "49" ...

    • RP-150 Controller - Using Presets

      To store Presets from your RP-150 Controller: 1) Press the PMEM/TMEM button on the controller 2) On the touchscreen, you'll see a list of preset buttons. To store a preset, first set your camera to a view that you want to save as a preset (For ...

    • RP-150 Controller - Turn on Wiper on 140 Camera

      Most of the Panasonic 140 Camera and RP-150 Controller combos are pre-programmed so that the User 6 button activates the wiper on the camera. But if that is not working, you can manually activate the wiper: 1) Press the Function button on the ...

    • RP-120 Controller is "Locked"

      1) Press the MENU button 2) Press button 25. RP SETUP 3) Use the F1 knob to select "4. ENABLE BUTTON" 4) Make sure the option is selected for "ACTIVE", otherwise use the F2 knob to change it. 5) Now use the F1 knob to select "5. MENU CONTROL". 6) ...