Replay (Teradek) - Change Video Output Bit Rate

Replay (Teradek) - Change Video Output Bit Rate

  1. Close all open Chrome windows. Press the "Windows Key" and the taskbar will come up. Right click on the Chrome windows to close. If two Chrome windows are open you will need to repeat this step for the second window.
  2. Press the "Windows Key" and launch a Chrome browser and input 10.0.0.100 in the URL box, and press Enter.
  3. The below screen will come up. Input the below information and click on "Login".
    1. Username = admin
    2. Password = Solutions8

  1. The following window will appear after logging in. Mouse over "Video Setup" to drop down menu options and select "Encoder Settings".


  1. The Encoder Settings window will be displayed. Change the Video Bitrate to 10Mbps.

  1. When 10Mbps is selected for the Video Bitrate, click on the "Apply" button on the bottom left of the screen.

  1. You will see "Please Wait" on the top right of the screen while the new settings are being sent. Takes approximately 5-10 seconds.
  2. When completed, click on the "Logout" button on the top right.
  3. Restart the computer system.

    • Related Articles

    • 8K Replay - Losing Frames or Artifacted Video

      This is an issue that may be more common with multi-stream Replay systems, but if a customer has a single-stream system but has multiple camera feeds going to a video switcher and then to Replay, this issue could pop up. The primary issue is that 8K ...

    • Replay - Running out of Disk Space

      If you run into an error message on Replay that says you are running low on disk space, you may need to delete some older clips or video that are saved on the hard drive: Minimize 8K Replay, and go into your C: Drive. Click into the SmartFieldVideo ...

    • Replay - This Video File Cannot be Played. Error Code 224003

      If you are trying to remotely view video clips from the 8K Replay system on an iPad, tablet, phone, etc and are getting a browser error 224003 that it cannot play the video file, the issue is likely to be that Windows Firewall is running on the ...

    • Lyvve Coach - Connecting 8K Replay

      To connect the 8K Replay case to the Lyvve Coach’s Connection Panel, the basic flow is to have a video source (Camera, mastRcam, etc) connected to the 8K Replay case, then connect the 8K Replay Case to the Lyvve Coach. Below is a diagram showing the ...

    • WTW - Unable to change video sources or inputs on the Streamdeck

      If you are trying to change your sources or inputs on the Streamdeck, but the walk through wall doesn't seem to update, you probably have multiple instances of the 8K Viewer running simultaneously. Close out all instances of 8K Viewer on the walk ...