Replay - Running out of Disk Space

Replay - Running out of Disk Space

If you run into an error message on Replay that says you are running low on disk space, you may need to delete some older clips or video that are saved on the hard drive:

  1. Minimize 8K Replay, and go into your C: Drive.
  2. Click into the SmartFieldVideo folder.
  3. Click into the PracticeVideo folder. In this folder you'll see other folders with a "date" stamp indicating dates in which Replay was used and video/clip were marked.
  4. You can delete those "date"  folders to free up space as they only contain video from previous sessions assuming you don't need to keep that video. Just make sure not to delete any of the other folders or log files.

    • Related Articles

    • Replay - This Video File Cannot be Played. Error Code 224003

      If you are trying to remotely view video clips from the 8K Replay system on an iPad, tablet, phone, etc and are getting a browser error 224003 that it cannot play the video file, the issue is likely to be that Windows Firewall is running on the ...

    • 8K Replay - Losing Frames or Artifacted Video

      This is an issue that may be more common with multi-stream Replay systems, but if a customer has a single-stream system but has multiple camera feeds going to a video switcher and then to Replay, this issue could pop up. The primary issue is that 8K ...

    • Lyvve Coach - Connecting 8K Replay

      To connect the 8K Replay case to the Lyvve Coach’s Connection Panel, the basic flow is to have a video source (Camera, mastRcam, etc) connected to the 8K Replay case, then connect the 8K Replay Case to the Lyvve Coach. Below is a diagram showing the ...

    • Replay (Teradek) - Change Video Output Bit Rate

      Close all open Chrome windows. Press the "Windows Key" and the taskbar will come up. Right click on the Chrome windows to close. If two Chrome windows are open you will need to repeat this step for the second window. Press the "Windows Key" and ...

    • WTW - Unable to change video sources or inputs on the Streamdeck

      If you are trying to change your sources or inputs on the Streamdeck, but the walk through wall doesn't seem to update, you probably have multiple instances of the 8K Viewer running simultaneously. Close out all instances of 8K Viewer on the walk ...