mastRcam - TruVu Monitor Color Calibration
The following steps detail how to perform a basic color calibrations on TruVu monitors. It’s important to note that every customer site will not be exactly the same and definitely not with the same lighting, so the following steps are more of a basic way to calibrate the monitors so the colors will match up closely between the UMR and the TruVu monitor.
Turn On Color Bars
- On the UMR-20, press the [USER 1} button to bring up the color bars.
- If this doesn't work, you can select [MENU] and go to Disp Setup. On page 2 of that menu, you can turn Color Bars to “On”. Then go back to the menu and go to Output Setup. Check the SDI MODE SEL to “Normal”
- You should now see the color bars on both the UMR and TruVu. Depending on the settings on the TruVu, your color bars will look similar to the image below:
Related Articles
mastRcam SC - TruVu Monitor Color Calibration
The following steps detail how to perform a basic color calibrations on TruVu monitors. It’s important to note that every customer site will not be exactly the same and definitely not with the same lighting, so the following steps are more of a basic ...
mastRcam (During Practice) - Using Color Bars on UMR-20 Recorder
To display color bars on your display, you’ll use the Panasonic UMR-20. Simply press the [User 1] button on the recorder and it will show color bars on the recorder’s display as well as the monitor. If this does not work, you can assign the User 1 ...
mastRcam (Before Practice) - Secure and Level the mastRcam
With the mastRcam in the spot you want it, the next step is to secure and level the trailer by lowering the stabilizer legs to the ground. 1. The first step is to make sure the wheel jack is touching the ground. 2. Next, on the Dashboard, locate the ...
mastRcam (Before Practice) - Systems Check / Functionality
Before raising the mast, we want to make sure functionally all the equipment is working. 1. Turn on power – Turn the red power knob on the console dashboard to the ON position. The inverter controller should turn on immediately where the cameras, ...
mastRcam (Before Practice) - Install Camera Housings
Some users will take down the cameras and housings after each practice and store them in a secure location, and others opt to just leave the cameras and housings installed. If you need to install the camera housings to the top of the mast: 1. Connect ...