mastRcam SC - Steps to factory default Kisea inverter.

mastRcam SC - Steps to factory default Kisea inverter.

  1. Turn off inverter (If not already off)
  2. Turn on inverter
  3. When inverter is showing voltage press and hold the “power” and “select” button at the same time until “CU” is shown on the display.
  4. With “CU” on the display press the power button several times until you see “FD” on the display.
  5. With “FD” on the display press and hold the “select” button until the hear the unit beep. Takes a couple of seconds and then “CU” will be displayed and the unit will reboot.

You shouldn’t need to re-cycle power to the inverter but may be good to do that to test to make sure settings held.