mastRcam (End of Practice) - Turn Off Power

Turn the red power knob on the console dashboard to the OFF position. The inverter controller (purple box next to the red power knob) will stay on, so you need to press and hold the power button on the controller for a couple of seconds and it will turn off after you release the button. Note that the inverter controller will stay ON if the mastRcam is plugged into shore power and charging. 

• Related Articles

• mastRcam Operations Checklist - End of Practice

  Below is a checklist that covers all the basics of using the mastRcam at the end of practice which includes breaking down all the components, preparing the trailer for storage, and charging the mastRcam. Lower Mast Remove Camera Housings or Put on ...

• mastRcam SC (End of Practice) - Turn Off Power

  Turn the red power knob on the console dashboard to the OFF position. The inverter controller (purple box next to the red power knob) will stay on, so you need to press and hold the power button on the controller for a couple of seconds and it will ...

• mastRcam (End of Practice) - Charge mastRcam

  The batteries of the mastRcam can typically go two practices between charging, but there’s no harm in charging the mastRcam after every practice. If the volt meter on the Console Dashboard reads 11.6 volts or less, then the mastRcam will need to be ...

• mastRcam (Before Practice) - Systems Check / Functionality

  Before raising the mast, we want to make sure functionally all the equipment is working. 1. Turn on power – Turn the red power knob on the console dashboard to the ON position. The inverter controller should turn on immediately where the cameras, ...

• mastRcam SC Operations Checklist - End of Practice

  Below is a checklist that covers all the basics of using the mastRcam SC at the end of practice which includes breaking down all the components, preparing the trailer for storage, and charging the mastRcam SC. Lower Mast Remove Camera Housings or Put ...