mastRcam (End of Practice) - Place mastRcam into Garage or Storage Area
Either push or tow your mastRcam into its desired storage area.
When towing the mastRcam, make sure not to travel over very bumpy terrain or over curbs as a large amount of jarring and vibration could cause damage or loosen bolts/screws which could cause safety concerns.
Also if you kept your camera housings on the top of the mast, make sure you have enough clearance to enter a garage door or other low area.
Related Articles
mastRcam SC (End of Practice) - Place mastRcam into Garage or Storage Area
Either push or tow your mastRcam SC into its desired storage area. When towing the mastRcam SC, make sure not to travel over very bumpy terrain or over curbs as a large amount of jarring and vibration could cause damage or loosen bolts/screws which ...
mastRcam Operations Checklist - End of Practice
Below is a checklist that covers all the basics of using the mastRcam at the end of practice which includes breaking down all the components, preparing the trailer for storage, and charging the mastRcam. Lower Mast Remove Camera Housings or Put on ...
mastRcam (End of Practice) - Remove Camera Housings or Put on Domes and Bags
Some users will take down the cameras and housings after each practice and store them in a secure location, and others opt to just leave the cameras and housings installed. If you need to remove the camera housings from the top of the mast: Push in ...
mastRcam SC Operations Checklist - End of Practice
Below is a checklist that covers all the basics of using the mastRcam SC at the end of practice which includes breaking down all the components, preparing the trailer for storage, and charging the mastRcam SC. Lower Mast Remove Camera Housings or Put ...
mastRcam (End of Practice) - Disconnect Guy Ropes & Close Bimini
If you attached the guy ropes to the mast for practice, you will want to disconnect them at this time. If you plan to use the guy ropes at the next practice, you can just disconnect them from the eye-bolts on the trailer and leave them connected at ...