mastRcam SC (End of Practice) - Charge mastRcam

mastRcam SC (End of Practice) - Charge mastRcam

The batteries of the mastRcam SC can typically go two practices between charging, but there’s no harm in charging the mastRcam SC after every practice. If the volt meter on the Console Dashboard reads 11.6 volts or less, then the mastRcam SC will need to be charged before the next practice.

The mastRcam SC requires a 20amp power circuit with a 12-gauge power cord (included with the mastRcam SC). 
1. Plug the shore power into the Power Inlet on the front of the trailer. The green “Charging/Shore Power” LED light will light up if power is detected and the trailer is charging.

2. Inverter will power on and, if charging, will show one of the following messages: 
a. FUL - By-Pass Mode. Battery is fully charged.
b. BUL-CHG - Battery charging in progress.
c. ABS-CHG - Absorption mode. This means the batteries are 90% charged.
If the trailer is NOT charging when shore power is plugged in, make sure the [120v AC In] breaker is ON.