mastRcam (During Practice) - Using the HD-100 Tilt Controller
On the Dashboard, you can use the HD-100 Image Processor Tilt Controller if you need to add image stabilization during windy days or rotate the image if you are unable to achieve perfect level with the mastRcam. The images below show what the Tilt Controller looks like for a dual camera mastRcam.
The Image Stabilization switch needs to be either ON (Up position) or ROTATE ONLY (Down position) in order for the Zoom and Rotation knobs to adjust your picture. If the switch is in the middle position, then the image stabilization will be turned off.
Turn on Anti-Sway if it’s windy enough to cause the mast to sway, and this will help stabilize the image.
Related Articles
mastRcam SC (During Practice) - Using the HD-100 Tilt Controller
On the Dashboard, you can use the HD-100 Image Processor Tilt Controller if you need to add image stabilization during windy days or rotate the image if you are unable to achieve perfect level with the mastRcam SC. The images below show what the Tilt ...
mastRcam - Gray bars appearing in video (HD-100)
This is a normal function with the stabilizer (HD-100) trying to stabilize the video while the camera is moving. However, if you want to turn the stabilizer OFF, then here are instructions on turning it off (depending on what version controller you ...
mastRcam SC - Gray bars appearing in video (HD-100)
This is a normal function with the stabilizer (HD-100) trying to stabilize the video while the camera is moving. However, if you want to turn the stabilizer OFF, then here are instructions on turning it off (depending on what version controller you ...
Invalid SDI Video or No Video Source (HD-100)
Typically if video is lost on the mastRcam camera system there are 2 types of errors you'll see on the monitor or UMR-20: NO VIDEO SOURCE AVAILABLE This error is typically a problem with the camera's signal and not the HD-100. You'll notice on the ...
mastRcam (Before Practice) - Systems Check / Functionality
Before raising the mast, we want to make sure functionally all the equipment is working. 1. Turn on power – Turn the red power knob on the console dashboard to the ON position. The inverter controller should turn on immediately where the cameras, ...