mastRcam SC (During Practice) - Recording Clips on UMR-20

mastRcam SC (During Practice) - Recording Clips on UMR-20

Once practice is in full swing and you’ve got your picture set up, the final step is to record clips. You’ll need an SD card inserted into the side of the UMR-20 as that is where all your video clips will be stored. When you are ready to mark clips, there are two ways to do this:
• Press the red [Rec/Pause] button on the UMR-20 to begin a new mark, and then press again to end the clip.
• Or you can use the 8K Red Record Button that is typically connected to your camera controller via a magnet. The button on that unit is connected to the UMR-20 and acts exactly the same as pressing the [Rec/Pause] button. 

    • Related Articles

    • mastRcam SC (During Practice) - Using Color Bars on UMR-20 Recorder

      To display color bars on your display, you’ll use the Panasonic UMR-20. Simply press the [User 1] button on the recorder and it will show color bars on the recorder’s display as well as the monitor. If this does not work, you can assign the User 1 ...

    • mastRcam (During Practice) - Recording Clips on UMR-20

      Once practice is in full swing and you’ve got your picture set up, the final step is to record clips. You’ll need an SD card inserted into the side of the UMR-20 as that is where all your video clips will be stored. When you are ready to mark clips, ...

    • mastRcam (During Practice) - Using Color Bars on UMR-20 Recorder

      To display color bars on your display, you’ll use the Panasonic UMR-20. Simply press the [User 1] button on the recorder and it will show color bars on the recorder’s display as well as the monitor. If this does not work, you can assign the User 1 ...

    • mastRcam SC (Before Practice) - Systems Check / Functionality

      Before raising the mast, we want to make sure functionally all the equipment is working. 1. Turn on power – Turn the red power knob on the console dashboard to the ON position. The inverter controller should turn on immediately where the cameras, ...

    • mastRcam (Before Practice) - Systems Check / Functionality

      Before raising the mast, we want to make sure functionally all the equipment is working. 1. Turn on power – Turn the red power knob on the console dashboard to the ON position. The inverter controller should turn on immediately where the cameras, ...