Lilliput Monitors - How to configure settings

Lilliput Monitors - How to configure settings

The Lilliput monitors come with built in scope and waveforms, but they need to be configured along with other settings. The following is a list of all settings they should be configured to:
  1. Press the Menu button to bring up the monitor OSD.
  2. Go into the PICTURE menu (use the left/right arrows to move selection, and press MENU to select)
  3. Change the Sharpness to 0 (use MENU to select the option, and then left/right arrows to change setting, then MENU again to save)
  4. Go back to the main OSD menu (use the EXIT button to go backward)
  5. Go into the WAVE menu.
  6. Make sure the Histogram option is set to OFF
  7. Go back to the main OSD menu and go into the SYSTEM menu
  8. Change the OSD timer to 30s
  9. Go back to the main OSD menu and go into the AUDIO menu
  10. Make sure the Level Meter is set to OFF
  11. Press EXIT to close out of the entire OSD menu
  12. Now, to program the F1 and F2 buttons:
    1. Press and Hold the F1 button until a menu pops up in the top right corner of the screen.
    2. Select WaveForm
    3. Press and Hold the F2 button and program it to Vector.
  13. Confirm that pressing the F1 and F2 buttons turn on/off the waveforms and vector