UE-150 Camera - Fixing "Sluggish" Camera Control

UE-150 Camera - Fixing "Sluggish" Camera Control

** AS OF DECEMBER 2020 - There is new firmware from Panasonic that fixes this issue. The steps below can be considered a temp fix until firmware can be updated

1. From your 150 Controller, press the MAINTENANCE button located on the right side of the controller. The touchscreen on the controller should look like the below picture:
 
2. On the Touchscreen, make sure you have “CAMERA MENU OP” active. Simply touch the menu to activate it, if needed.
3. Now, use the F1 knob to change the “Menu” option to “ON”. The text will flash until to press in the F1 knob to accept the change. Once you do that, a menu should appear on your TruVu monitor

4. Use the F2 knob to scroll through the menu options and when you are on “Pan/Tilt”, press in the F2 knob to activate that menu.

5. Now, scroll down to “P/T Speed Mode” and press in the F2 knob. This will allow you to change the setting to “Fast”.
6. That’s it! You can go back to the touchscreen on your controller and use the F1 knob to change “Menu” back to “Off” to get rid of the menu on the TruVu. You should no longer have sluggish control over your camera.

    • Related Articles

    • RP-120 Controller - Unable to control camera

      1) First power cycle both the camera and controller 2) If that doesn't fix the issue, press button 36 CTRL TYPE and make sure CAM 1 is set to "Serial" 3) Also make sure that the 422 cable connecting into the controller is in Port 1 (But not the LAN ...

    • mastRcam (Before Practice) - Secure and Level the mastRcam

      With the mastRcam in the spot you want it, the next step is to secure and level the trailer by lowering the stabilizer legs to the ground. 1. The first step is to make sure the wheel jack is touching the ground. 2. Next, on the Dashboard, locate the ...

    • mastRcam (Before Practice) - Systems Check / Functionality

      Before raising the mast, we want to make sure functionally all the equipment is working. 1. Turn on power – Turn the red power knob on the console dashboard to the ON position. The inverter controller should turn on immediately where the cameras, ...

    • mastRcam Operations Checklist - Before Practice (1 hr before start)

      Below is a checklist that covers all the basics of setting up the mastRcam before practice. We recommend that you start this at least 1 hour before the start of practice so that if you have an issue, there will be time to resolve the issue or call us ...

    • mastRcam (Before Practice) - Install Camera Housings

      Some users will take down the cameras and housings after each practice and store them in a secure location, and others opt to just leave the cameras and housings installed. If you need to install the camera housings to the top of the mast: 1. Connect ...