Customize Camera Labels in Blackmagic MultiView

Customize Camera Labels in Blackmagic MultiView

Download Multiview software here: https://www.blackmagicdesign.com/support/family/multiview-monitoring

 

CUSTOMIZING INPUT LABELS

Labeling your sources lets you quickly identify each source within the multi view layout. You can also save and load label sets.

 

To customize your input labels:

  1. Click on the SOURCES tab.
  2. Click the text box for the input source name you want to change and enter a new label name.
  3. Click “Save” to confirm your setting


    • Related Articles

    • Customize Camera Labels on Decimator Multiviewer

      Download the latest Decimator Control Panel software at https://decimator.com/DOWNLOADS/DOWNLOADS.html Once you've connected to your Decimator multiviewer (via USB A --> USB B mini) within the Control Panel software, click on the UMDs tab. In this ...

    • RP-120 Controller - Unable to control camera

      1) First power cycle both the camera and controller 2) If that doesn't fix the issue, press button 36 CTRL TYPE and make sure CAM 1 is set to "Serial" 3) Also make sure that the 422 cable connecting into the controller is in Port 1 (But not the LAN ...

    • UE-150 Camera - Fixing "Sluggish" Camera Control

      ** AS OF DECEMBER 2020 - There is new firmware from Panasonic that fixes this issue. The steps below can be considered a temp fix until firmware can be updated 1. From your 150 Controller, press the MAINTENANCE button located on the right side of the ...

    • mastRcam SC (Before Practice) - Install Camera Housings

      Some users will take down the cameras and housings after each practice and store them in a secure location, and others opt to just leave the cameras and housings installed. If you need to install the camera housings to the top of the mast: 1. Connect ...

    • mastRcam (Before Practice) - Install Camera Housings

      Some users will take down the cameras and housings after each practice and store them in a secure location, and others opt to just leave the cameras and housings installed. If you need to install the camera housings to the top of the mast: 1. Connect ...